1. The table is made of pine and, it is finished with three coats of spray polyurethane. I sand it the finish after each spray, which leaves a semi-smooth finish on the pine. Each table is made with new pieces of wood, so the grains will run differently than shown in the photos.  You can also have the outside of your Dix Table stained with your favorite stain color - See below for additional pricing.

2. The table measures 26 inches high, by 19 1/2 inches wide, and 13 inches deep. Keep in mind, when you attach your c-clamp vise (or use a pedestal vise on the table-top), you are adding another 7 - 10 inches in height to your work space. So, you are actually working at 33 - 36 inches (see photo, below right for a table in use.

3. Each side of the table is enclosed with a paneled wall - including the front door.  This was originally requested by one of my customers to keep his small dogs out of his tying supplies!

4. The spool rack is two levels and extends 18 inches across the table. It holds 21 spools.

5. A magnetic strip has been placed along the bottom of the spool rack for drying flies or placing small hooks to be used.

6. On the left and right side of the top of the table there are instrument slots - 14 total.

7. The two shelves allow you to store many of your supplies, like hooks, bead heads, hackle, bucktail, etc (photo, below right).

8.  A Trash Hole with Magnetic Bin has been added in the middle of the table top to help you easily remove your waste.  Just scrape all your waste into the hole, open the front door, pull the Bin out and dump your trash - it's that easy!

9. The vise bar, which runs 15 inches across the front of the tabletop, is made for either right, or left-handed folks.

10. Your table will be personalized with a black brass nameplate across the front.  You pick what you want it to read!

11. Wood screws are used to connect all pieces, and flat, wood plugs are placed in the recessed holes to hide the screws.